Water Heater in Stonebridge, Barrhaven,

Three flashing lights and no hot water. That’s what a homeowner in Stonebridge woke up to, and the unit was showing a thermal cut-off or pressure switch fault. Not something a reset fixes on its own.

We had actually installed this power-vent water heater the year before, so we knew the unit well. The before photo shows the data label up close, a 60-gallon natural gas power-vent model. Still relatively new, so the goal was to get it running again rather than replace it.

We checked the exhaust vent for any blockage outside, which the homeowner had already looked at too. Then we worked through the fault properly. The thermal cut-off and pressure switch circuit needed attention. Once we sorted out what had triggered the lockout and addressed it, the unit came back to life.

The after photo tells the rest of the story. The heater is standing clean and fully connected in the utility space, all lines in order, running the way it should.

These power-vent units are reliable, but when a fault code shows up, it pays to have someone who knows the system come take a look rather than guessing through it. We were glad this one didn’t need a full replacement.

If your water heater is flashing a fault code or just not keeping up, give us a ring at 613-454-5585 and we’ll figure it out with you.